5.6.2. Scenario Commands

Integrator commands

Table 5.10 Integrator commands

Type	Para meters			Integrator command
ADV(ADVANCED)	Maximum Step Size	Error Tolerance	Numerical Damping	INT/ADV, HMAX = 0.001, ERR = 0.005, NDA = 1.0

Note

You must define the Integrator command prior to the Simulation command.

During the Simulation, the user cannot change the integrator type.

Simulation commands

Table 5.11 Simulation commands

Type	Parameter			Simulation command
Dynamic	End Time	Step		SIM/DYN, END=5, STEP=100
Static	End Time	Step		SIM/STA, END=5, STEP=100
Eigenvalue	No. of Frame			SIM/EIG, CYCL = 30
FrequencyResponse	Start Freq	End Freq	Freq Step	SIM/FRA, SFREQ = 0, EFREQ = 1000, FSTEP = 100

Note

The Frequency response analysis must be defined once in a scenario analysis.

Equilibrium commands

Table 5.12 Equilibrium commands

Parameter				Equilibrium command
Error Tolerance	Maximum Iteration	Tra. Move Limit	Rot. Move Limit	EQU/ ERR = 0.001, MAX = 100, TML = 20.0, RML = 10.0

Note

This command is static analysis option. The static solver type is defined in Static Analysis dialog.

The Tra. Move Limit and Rot. Move Limit commands are only applied in N-R static solver type.

You must define the Equilibrium command prior to the Static Analysis command.

EigenParameter commands

Table 5.13 EigenParameter commands

Parameter		EigenPara command
Max No. Mode	Including damping (Damped/Undamped)	EIGPARA/MAXMODE = 10, DAMP = TRUE

Note

This command is eigenvalue analysis option.

You must define the EigenParameter command prior to the EigenValue Analysis command.

Activate/Deactivate command

The Force, Contact, FFlex Body, and RFlex Body can be used as Activate entity in the Scenario command

Note

The professional force and contact are all available

FRAParameter commands

Table 5.14 FRAParameter commands

Parameter				FRAPara command
Max No. Mode	Animation Frame	Including damping (Damped/Undamped)	Logarithmic Step	FRAPARA/MAXMODE=10, CYCL=30, DAMP=TRUE, LOGSTEP=FALSE

Note

This command is frequency response analysis option.

You must define the FRAParameter command prior to the Frequency Response Analysis command.